How To Repair Broken Sprinkler Pipe

Download Commodity

Download Article

If there are areas of your lawn that look more similar to a marsh than a backyard, you may take cleaved sprinkler pipes. Fortunately, fixing the problem isn't too hard if you don't heed getting dirty.

Steps

1. ane

   Ensure you have all the required supplies. Nothing is worse than having to run to the hardware store in the middle of a project. See the list of things you need below.

2. 2

   Find the rupture. Ordinarily a soggy area of grass, but sometimes it is a geyser.

   Advertisement

3. 3

   Turn off the sprinklers, if you lot don't this could be a very hard task.

4. 4

   Dig up the pipage. Not the whole pipe, but the department that is broken. Carefully remove the section of grass above the pipe, trying to go on it intact. Exercise this by cut a round section with the end of your shovel above where you are to dig then carefully lifting it off. Dig upward the dirt above the bad pipe with a shovel (yous will probably also need a hand trowel to dig up the dirt under the pipage). Yous will desire to accept at least six inches (15.2 cm) on each side of the break clear and plenty room for you fist underneath the pipe. If the hole fills with water, you will either have to look for it to dry or bail it out (the latter is recommended).

5. v

   Cut the piping. Become a hacksaw, PVC or metal pipe cutters (depending on what blazon of pipe you have, older sprinkler systems are usually metal, while newer ones tend to be PVC). Cut the cleaved section out and so that you lot have clean, undamaged pipe on both sides.

6. half dozen

   Measure a new length of pipe that is only a bit shorter than the gap left by old pipe that y'all cutting away. It should probably be 1/ii " to 1" shorter to allow room for the connectors. Or you tin can buy a PVC fitting from almost home comeback stores that has one piping sliding inside an outer barrel with an O-ring inside. It will extend virtually iii" in length. Y'all may run into in stores one/2" to 2 1/2" in diameter sizes. One terminate is a female slip and the other is a male person that needs a coupling, elbow, or tee to connect to complete the repair.

7. 7

   Clean the pipe. Some water will come pouring out at get-go, you could attempt to catch information technology, just information technology is easier to bail it out. Once the water stops coming out, clean both ends with a rag.

8. 8

   Fit the new section. If you are lucky enough to have PVC and so you just put the PVC primer and glue on the outside of the pipage and inside of the straight connectors and slip them together. Work quickly considering the glue sets fast. So put the section you just glued in the gap you merely created, repeating the gluing procedure. If y'all have metal pipes you lot volition accept to thread the outside of the pipe to fit the connectors rather than gluing them.

9. 9

   Test the pipe. Plow the sprinklers back on and make sure it is sealed properly.

10. 10

    If everything is fixed, embrace up the hole and replace the grass you so carefully removed before.

Advertizement

Ask a Question

200 characters left

Include your email address to go a bulletin when this question is answered.

Submit

Advertizing

Thanks for submitting a tip for review!

• Be conscientious when digging, you never know what you might hit with your shovel.

Advertizing

Things You'll Need

• Shovel & trowel
• Piping
• 2 straight connectors
• hacksaw or pipe cutter
• for PVC, glue and primer
• for metal, a threader
• Rags
• 2 Hours

Most This Commodity

Thanks to all authors for creating a page that has been read 53,527 times.

Did this article help you?

Source: https://www.wikihow.com/Fix-a-Broken-Sprinkler-Pipe

Share this post